Supportp3admin2019-06-19T23:27:07+04:00 Hardware How to plug in the power cord correctly How to clean the Bowden tube Remove the nozzle ring Materials Custom material profiles for Ultimaker 2 and Ultimaker 2+ How to insert filament How to store material Maintenance Ulti-Evening: Maintenance How to apply the Atomic Method? How to fix the most common Ultimaker error messages? How to unclog an Ultimaker nozzle? Upgrade tutorials Ultimaker Original dual fan upgrade Ultimaker Original 1.75mm filament conversion Ultimaker Original improved Z-limit switch Dust filter Ultimaker Original custom firmware builder Software Gcode flavours: Reprap vs. UltiGCode Using old Cura profiles in the new version Machines and profile settings in Cura 2.1.0 and higher Loading multiple objects in Cura How to use and install Cura plugins Maximum build volume of Ultimaker 2+ and Ultimaker 3 3D prints How to improve build plate adhesion with design orientation Build plate adhesion: How to get your print to stick to the build plate Bridging How to fix an ugly print What does a successful first layer look like? How to remove your print from the build plate Print tutorials e-NABLE prosthetic hand Vertical Axis Wind Turbine Airplane model Manifold model with support Erasmus bridge tutorial Drooloop flowers Tyrannosaurus rex – Splitting large models General knowledge base Safety and Compliance Ultimaker manuals Third-party products Ultimaker warranty Terminology General questions Where can I find official Ultimaker resellers? What is g-code?